With these pegs fit on the GS ?

[dorian chapman]

with a little grinding like pantablo's website says....

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&rd=1&item=2487312290&category=35588

if not, what peg's should i be looking for ? I am looking for the all metal look as seen on that item.

[TR]

I think you should look for a full set of pegs, because you only could install left one since right one has only the peg... on the other hand, once you have a set of pegs like these, if you grind off current pegs and weld a set of brackets to the frame then will be pretty easy to fit them.

You better take a look at John's instructions on how they installed a set of SV pegs, check SV Rear Pegs in Modification in gstwin.com, like John use to say, it's more than a board...

[dorian chapman]

i thought i only need the peg part ? Cause i want to stick 'em on the front ones.  I'll leave the rears stock as i don't sit back there !

So i thought this would be a perfect item, as the price will be low cause half is imissing, but i don't need that bracket part..........or do I ?

[mjm]

i thought i only need the peg part ? Cause i want to stick 'em on the front ones.  I'll leave the rears stock as i don't sit back there !

So i thought this would be a perfect item, as the price will be low cause half is imissing, but i don't need that bracket part..........or do I ?

Yes, with a little grinding they should fit - I used Yamaha rear pegs ground to fit in the front brackets