I GIVE UP!

[pprider]

so i FINALLY got the master clip on but it wont clsoe all the way like its not seating right but its practically all the way on there, to top that off the link acts like its frozen doesnt move freely liek the rest maybe it has to do with the way its seated i dunno

to top it all off for the heck of it i tried to run throught the gears on the centerstand to make sure that was right... wont go outta nuetral guess i fooked somehting up when i did the front sprocket GRRRRR :x  :x

[pprider]

hmm ok so i took it off the center stand and it changed to 1st then to nuetral but it wouldnt go into 2nd i sat there for a minute pulling up and then it finally "found" 2nd then it would go to nuetral then it wouldnt go to first BAH what did i do?!

[mjm]

hmm ok so i took it off the center stand and it changed to 1st then to nuetral but it wouldnt go into 2nd i sat there for a minute pulling up and then it finally "found" 2nd then it would go to nuetral then it wouldnt go to first BAH what did i do?!

Most likely nothing - you just need to move the countershaft sprocket around a bit (forward and back) to allow things to line up in the tranny.  Common event - nothing to get excited about.