GSXR Exhaust Question

[ponchopirate]

So I just got a stock exhaust can dirt cheap on ebay off a 2002 GSXR 1000 and I have couple questions.  Is it practical to assume I can find some way to attach it to my bike?  Will one of Srinath's adapter's from his cans work?  How much does this can breath?  In other words, when I rejet does anyone have any suggestions as to what size main jet to use (I also have a Uni foam filter that I'll be dropping in the stock air box).  Thanks!

[GRU]

i made my own flange



the carbs have 150 main and 40 pilots.....it's a good can for the setup

[ponchopirate]

Sweet!  Did you just hack your stock muffler off near the weld and then weld the GXSR can on?

[Dom]

You can definitely do just that.  If you will notice, GRU had to make a hanger bracket, because apparently the stock hanger was incompatible with the new can.  So there will be little issues like that but if your handy with a welder and a sawzall, pretty simplistic.

[GRU]

i don't have time to explain how i did it but check out my site
http://www.automotoklub.net/intakeexhaust.htm
if you got any more questions i'll answer them later

[The Buddha]

I would have hacked the header pipe 2-3 inches off the weld on the bottom of the motor and made mt mid pipe from there ... If you want that ready made ... I can send you a hole less flange and mid pipe ... or send me a exhaust gasket and I'll drill it for that ... But My flange is round ... I cant cut that wavy pattern ... OK I may be able to do a square flange ... the round one is thick ... like 3/16+ inch thick ... cutting it ... nope ... Might as well do square ...
Cool.
Srinath.