Well, I have to much time on my hands anyway(my new project)

[Jay_wolf]

Sounds really good buddy  , for some really wierd reason , i dont want my gs anymore ,i think its becuase the project is basicly at the end , and i just want to finish it , Paint , the rear wheel , and the little bits and bobs , i want a Thumping Single Enduro , hopefully with a few mods .

[yamahonkawazuki]

My Vicegrips are broken.......don't ask.  May as well buy a new pair and try it

Ummm, dunno if you've noticed....but carbs ain't cheap   And they are already setup for the bike   can't find a pilot size but it's running 132 mains.........

http://cgi.ebay.com/ebaymotors/1986-SUZUKI-GSXR750-GSXR-750-CARBS_W0QQcmdZViewItemQQcategoryZ34284QQihZ014QQitemZ330146013409QQrdZ1QQsspagenameZWDVW

http://cgi.ebay.com/ebaymotors/88-GSXR750-GSXR-750-KATANA-CARB-SET-5A20_W0QQcmdZViewItemQQcategoryZ35597QQihZ013QQitemZ230153782797QQrdZ1QQsspagenameZWD1V

[spc]

Meh.......my uncle is bringing some tools and a torch.......I'm bringing my carbs.........this damn pilot jet is coming out if someone has to go to the hospital because of it   seriously.

Any real benefit of going back to stock flatside carbs from these??

[werase643]

ya know....
I'd check to see what diam carbs on on the 750 and compare them diam wise to newer kat 600/750
the spacing is the same since it is an evolution of the same engine.

they are prob 32-34 mm range....therefore a modern kat 600 might slap right on there
if bigger you might need the intake boots....and a mild port job to get rid of a ridge.

[spc]

HEY KEN!!!!
How's this turd looking, ever figure out something for the subframe??  better yet, get it running??

[werase643]

checked the mail yesterday.....no title.....yet


it sit's til i see paper....otherwise i have a pile of parts