gauges panel replacement !

[DaxFX]

my gages are ugly and old i search everywere for buy new ones or mint condition used. with no luck
there any aftermarket a different bike or something that can be fit on the GS !! any universal gauges diferent bike model !! I dont know some1 can help !

[dgyver]

I do not know of any direct replacement gauges.

But other gauges can be adapted, depending on your ability.....

I have 1st Gen (99-02) SV650 gauges on my 97. I modified a SV speed sensor to fit the GS axle. Just had to make a bushing to fit in the inside.
My 92 has '02 SV650S gauges. Still working on the speedo sensor for the GSXR front end, which requires 4 magnets attached to the rotor.

The tachs and lights were easy to wire, just need to be able to read a wire diagram.

[Nikolas]

What's ugly about yours?  You could probably spruce them up and make them better than new.

[Suzuk-E]

http://gstwins.com/gsboard/index.php?topic=36893.0

[DaxFX]

What's ugly about yours?  You could probably spruce them up and make them better than new.

the plastic housing is crack and have some holes . the tacho has burn in the back by the bulb and the inside of the tach panel is burned and you can see thru the black the light. i will post some photos tomarrow !!

[frankieG]

the acewell is gawd awful ugly...i like the standard gauges but a sv set would look pretty good too

[slowinthestraights]

the acewell is gawd awful ugly...i like the standard gauges but a sv set would look pretty good too

I wouldn't say its very ugly at all. Much better looking than the stock gauges.

Here are a few pics, Im planning on getting one as soon as I get the money. They run about $150, not bad at all. The US distributor for them is 60 miles from me.





This one shown with the surround you get with certain models to replicate all the stock LED function.

[ben2go]

the acewell is gawd awful ugly...i like the standard gauges but a sv set would look pretty good too

I wouldn't say its very ugly at all. Much better looking than the stock gauges.

Here are a few pics, Im planning on getting one as soon as I get the money. They run about $150, not bad at all. The US distributor for them is 60 miles from me.





This one shown with the surround you get with certain models to replicate all the stock LED function.

I wanted to use one of these on the bike I'm building.Any one use this before?

[DaxFX]

that acewell use mecanichal cables or electrical cables for the tacho and speedo . in the photo looks like it was mechanical cabl like GS gauges!

[frankieG]

can't like them at all, they look like cheap pda's you find at mardens

[Jay_wolf]

Its Electrical , my one , the model 3100 , a single wire that goes round the coil , for the RPM , then a wire that goes down , with a small magnet attched to the Front wheel , its easy and looks good , my tastes tho

[The Antibody]

If you just want to freshen up your stock ones...

http://cgi.ebay.com/ebaymotors/Suzuki-GS500F-Meter-Cover_W0QQitemZ290140156628QQihZ019QQcategoryZ35583QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

  -Anti