The price was right

[spc]

I got it on!!!! install took like 20 minutes....mostly because I had to figure out the high/low beam wires.......no directions with it   looks pretty good but my camera battery is charging and I have to leave for work in a couple of minutes   So very late ( 0100 ) or sometime around lunch tommorow

[Jay_wolf]

looking forward to it

[ben2go]

Hey.My R1 tail light arrived this morning.It's a 2000-01 clear tail light with red inserts,
made by Clear Alternatives.It is a good quality light and I only gave $30US for it on Ebay.
I had to thread the mounting holes,and trim a little tab off of the bulb sockets on the
bike.I had some stainless fine thread screws and they worked great.I started this morning
taking ever thing apart so I could make some tank spacers.My rubber mounts were shot.
It took me about 2 and a half hours to strip the bike down,cut the spacers,talk to the
delivery lady(OOOLALA),fit the light,and put it all back together again.Works like a dream.
The reason why it took me so long is because i had to flirt with the delivery lady,and check
the fit of the tank.The light by itself should take only a half an hour.

Here is the tools I used.
flat and phillips screw drivers
6mm allen wrench
10mm and 12mm sockets
rachet and 6 inch extention
1 inch tubing cutter(for cutting tank spacers out of 3/4 sch40 pvc pipe
razor knife/utility knife for trimming the tabs on the light sockets

[Nominally Lucid]

Looks like...

Not sure why, but I always think of Johnny Five when I see those headlights.

Kinda reminds me of Sigourney Weaver . . .

[kilmer]

Did you ever get this headlight on, any picts?

[kml.krk]

I'd love to see the pics also.

[kdogg84]

yeah let's have a look!

[Jay_wolf]

Ive seen these and they look rubbish , terrys Gs was totalled by a drunk redneck

[Jay_wolf]

[mach1]

Looks good jay . Im kinda glad I didnt do the kat front end the bars look too high for my riding style(too upright),

[kdogg84]

that looks a lot better than i thought it would! just too bad the colour doesn't match the paint job on the tank

[lancemclaughlin]

wow! that looks really nice! if that's plastic, it shouldn't be too hard to paint to match the tank..
nice, though! very nice!

[Jay_wolf]

Its all being Painted soooooon! , the only delay is that ive found a rear tail i really like , even , tho i like the stock one , its gonna be in one Blue ,Either Midnight blue, or a Darker one

[kdogg84]

Its all being Painted soooooon!

nice one!

[Jay_wolf]

Oh Mach1 , I mounted the clip ones , Above the yoke , i can mount then underneath , but i find this way more comfy