Possible causes for dead turn signal & hi/low beam indicators?

[TurkeyChicken]

I've had my bike since October and have dealt with this issue, but it's finally starting to get to the point where i want those indicators working.

They simply don't do anything if my turn signals are on or if my high beam is active.  Is there a set of steps I should take to troubleshoot why they aren't working?

I'm not sure if it's dead bulbs, a bad fuse, broken wire, etc.

Any help on where to start the search would be great!

[sledge]

Checking the bulbs would be a good starting point.

[TurkeyChicken]

I'm assuming they just pull out?

[TurkeyChicken]

It was the bulbs.  The new ones aren't as bright as the neutral and oil lights, but they'll do for now.  at least i have an indicator.

They sure were a pain in the balls to remove though 

[sledge]

If you unfasten the tacho and speedo cables then undo the two 10mm nuts on the chrome headed bolts either side of the pilot lights you can move the whole panel a couple of inches forward. It gives you a bit more room to play with and makes replacing the bulbs a lot easier......but I guess its doesnt matter now.

[TurkeyChicken]

If you unfasten the tacho and speedo cables then undo the two 10mm nuts on the chrome headed bolts either side of the pilot lights you can move the whole panel a couple of inches forward. It gives you a bit more room to play with and makes replacing the bulbs a lot easier......but I guess its doesnt matter now.

yeah, that's basically what i ended up doing.  i still need the little plastic cover for the turn signal indicator.  it's been missing since i bought the bike.