News:

Need a manual?  Buy a Clymer manual Here

Main Menu

spark but no fire

Started by zeusrekning, October 20, 2009, 05:12:22 PM

Previous topic - Next topic

zeusrekning

I noticed this weekend that my engine was missing. I felt the header tubes and my right was warm left was cold. Long story short I removed the wire thinking it was bad, and made a terminal to screw onto the thread that went into the original wire so I could use a regular automotive coil. I tried running it again with no luck. I took the spark plug ou and it was wet and would spark to the frame well. Any ideas where I should go from here?

The Buddha

Auxillary ground.
Cool.
Buddha.
-----------------------------------------------------------------
I run a business based on other people's junk.
-----------------------------------------------------------------

zeusrekning

Thansk for the help Buddah but could you clarify that for me?

zeusrekning

I just went out and swap the coils around. And now my engine is running. Not very smooth but running. Should I just buy new coils?

The Buddha

OK here is a Q, did the problem switch sides ?
And, If the problem is that it misbehaves when cold, that could be a bad crank trigger plate.
Cool.
Buddha.
-----------------------------------------------------------------
I run a business based on other people's junk.
-----------------------------------------------------------------

zeusrekning

#5
No the problem was semi resolved when switching sides. It will idle fair right now but starts missing bad at higher RPM. Tach is not connected atm, but I would say around 5k rpm it misses bad. Also, it does idle worse than it was a month or two ago. But it also has been cooler outside.

SMF spam blocked by CleanTalk