advice on these flushmounts

[remo2k9]

hey im thinking if i shud buy these flush mounts for front n rear.. but problem is they are flat surface and also adhesive backing Fitting.





i want to put them on these locations.. but see how the surfaces aint FLAT so i donno how they will looooook............ i really want these they cost only 5$ AUD ! omg... please some aadvice!

[bassmechanicsz]

you might be able to use some rubber between the blinkers and the fairings to get a slight contour out of the rubber since i don't believe that their is a lot of curvature on the parts of the fairings you are wanting to put these blinkers.

Another thing you could do if you were able to do fiberglass is almost make like a pod out of fiberglass that seamlessly blends into the fairings but allows the blinkers to mount in nicely.  Would be a shame to need to shoot more paint though as in the picture looks like you just finished painting the bike.

[remo2k9]

you might be able to use some rubber between the blinkers and the fairings to get a slight contour out of the rubber since i don't believe that their is a lot of curvature on the parts of the fairings you are wanting to put these blinkers.

Another thing you could do if you were able to do fiberglass is almost make like a pod out of fiberglass that seamlessly blends into the fairings but allows the blinkers to mount in nicely.  Would be a shame to need to shoot more paint though as in the picture looks like you just finished painting the bike.

hmm i jst checked my bike and on the front fairing way too unflat lol its like impossible to put it there unless i putty and sand =.= and also the back thers no straight surface , sorry for this useless thread LOL im a pulse buyer i saw it was cheap was ALMOST giong to buy it , my bike doesnt get back till 730pm daily so i cudnt check it but luckily no1 in the forum rplied LOL