Dent in V&H

[mass-hole]

I just bought a Vance and Hines used and it has a dent in it on the midpipe. Luckily it is only about 2-3 inches from the connection between the midpipe and headers so I can reach it fairly easily. Does anybody have a good suggestion on how to pop the dent out, or has anyone taken it to a shop to get it done? Or am I out of luck.

Thanks,

Jay

[tt_four]

You can get things that are meant to spread out header pipes so they fit over other pipes. They sell them pretty cheap at harbor freight and other auto part stores. I'd but one of those, heat up the dent, and start expanding the tool. I would think it would pop out the dent before it got around to stretching anything else out. If you want to be sure you could probably wrap a couple hose clamps around it to keep the pressure on that one spot.

[romulux]

You can get things that are meant to spread out header pipes so they fit over other pipes. They sell them pretty cheap at harbor freight and other auto part stores. I'd but one of those, heat up the dent, and start expanding the tool. I would think it would pop out the dent before it got around to stretching anything else out. If you want to be sure you could probably wrap a couple hose clamps around it to keep the pressure on that one spot.

Good idea.  He might be able to take it to a shop that has a tool like that and get them to do it for really cheap.

[mass-hole]

Good call.

Is this what you mean: http://www.harborfreight.com/medium-tail-pipe-expander-37353.html

[tt_four]

that's exactly what I was talking about

[mass-hole]

Awesome, thanks a lot for the help!

Jay