Unable to get K&N filter on Carbs

[warlock214]

Just got my new set of carbs and I'm unable to re-install the filter. Got one side connected, but unable to line up and put on the other side! Any suggestions?

[Big Rich]

I am probably wrong, but do the new carbs have the same spacing between the intakes as the old ones?

Could try dipping JUST the sleeves/boots of the filter in some boiling water. Should soften up the rubber enough to get them installed.

[warlock214]

Thank you Big Rich! It worked! Don't know what happen to the filter. This forum is the best!

[Garrett]

Getting the carbs on the manifolds and the filter on the carbs is such a pain in the duck

[ben2go]

I have no issues.I don't understand why so many others do.On other bikes I have had issues.I usually lay the air filter/housing in the sun while I work or use a hair dryer to soften the boots.A little WD-40 or swipe of motor oil will help them slide on easier.