News:

New Wiki available at http://wiki.gstwins.com -Check it out or contribute today!

Main Menu

inline fuel filter

Started by Puunjob, December 12, 2003, 11:27:16 AM

Previous topic - Next topic

Puunjob

I recently added an inline fuel filter and in order to make it fit I had to add about a foot of hose.  (extra hose runs under the air box then makes a turn to reach the petcock with the fuel filter) Could this affect how much fuel my bike is getting?
Rubber down Paint up
                 -MSF Intsructor

Adam R

Only if the line is more likely to get pinched.  Adding a few inches of hose shouldn't affect the fuel rate.
Current bikes:
1993 Honda NSR 250 SP
1994 Suzuki RGV 250 RR SP
1993 Yamaha Seca II

kyzee

Speaking of the inline fuel filter, does anyone know if it will filter water from getting into the carb? I have a problem of the engine running like crap once in a while. Problem usually encountered after clocking like say 60 miles (from a full tank). Which leads me to believe there are some dirt or water inside the tank. I do not have that problem if I keep topping up the tank before 60 miles.  :dunno:
It is not good enough to say that we are trying our best. We must succeed in doing what is necessary.

Flash

The inline fuel filter will not filter out water.

It works the same way a coffee filter works for making a pot of coffee. It blocks the coffee grounds (dirt or debree) and allows the water (gasoline or any other liquid) to "filter" through.

If you are pretty sure you have water or debree in your tank your best bet is to take your tank off and check for leaks and/or rust. By identifying the specific problem you can treat it accordingly with a sealing or anti-rusting compound.

Hope this helps.


"A bad day of riding is better than a good day at work."

'96 Mods: Bob B. ign. advancer, 40 pilot/125 main jets, 15T fr sprocket, fenderectomy, 1/2" fabr fork brace, Pingel petcock

kyzee

It is not good enough to say that we are trying our best. We must succeed in doing what is necessary.

Cal Price

Getting water out of the fuel, just a piece of trivia and well O.T. it's a common problem in ships, especially warships where water is often used to dispace fuel oil thus keeping the tank full, negating the free surface effect and increasing stability. It's done with a centrigue that would be just a tad large for a bike but one of the geniusus might like to work on it!
Black Beemer  - F800ST.
In Cricket the testicular guard, or Box, was introduced in 1874. The helmet was introduced in 1974. Is there a message??

clkeith50

A slightly easier method might be to get some denatured alcohol (I get it at Home Depot) and put about 1/2 quart of it in a tank of gas. The alcohol will absorb the water and mix with the gas so the water will burn off with the gas instead of settling in the bottom of the tank.

Cal Price

Without question, much more practical, but where's the challenge and the fun it that?
Black Beemer  - F800ST.
In Cricket the testicular guard, or Box, was introduced in 1874. The helmet was introduced in 1974. Is there a message??

SMF spam blocked by CleanTalk