Massive Part Out: Lots of Good Stuff

[milezero5]

Well, I'm adding another bike to the staple and the wife says one of them has to go so the project will be parted out. There are a lot of good parts in the mix and if you don't see something that you need just ask as I probably have it. If you would like to buy everything as a whole, pm me and we can work out a deal (Have clean title in hand).

The good: Most of the parts are new or have been cleaned/ painted.

The bad: The motor is in need of some work, I purchased the bike not running and never determined the source so the motor will need to have some work. Valves are out of spec, one of the valves is stuck open, and the stator was toast when I took it out other than that it has good compression and has about 24k in mileage.
The best way to reach me is via email:     milezero5@yahoo.com
Now to the parts
Prices do not include shipping and everything is best offer
















Front wheel (repainted, bearings spin freely, rotor in good shape)
With a new Avon road rider front tire       160
Rear wheel (repainted, bearings spin freely, rotor in good shape, JT oem tooth sprocket in good shape)
With Kenda Cruiser S/T tire 90% tread      160
Front brake caliper (03 sv650) with good pad life and used front brake line     40
Rear brake caliper with good pad life and stainless steel line as well as master cylinder     50
Front forks (repainted gold, new progressive springs, fresh 15w Suzuki fork oil, new fork seals)     
Includes oem fork brace    160
2006 R6 rear shock in great shape including all needed linkage to install       70
Sigma bike computer        20
Clip-ons (unknown ebay brand)      50
Turn signal/ Kill switch controls (newer style from an F model)       40
Headlight and housing         40
Bike master chain (new in package)   60
Vance and Hines exhaust (sandblasted and unpainted, has some scrapes on the muffler section)   
  Make offer
Ebay foot pegs grinded down to fit (includes mounting brackets)       30
New oil pan gasket     20
New stator cover gasket     20
New cam chain tensioner gaskets x2      5 each
New coil packs                Make offer
New spark plugs x2          3 each
New clutch cover gasket     20
JT 15T front sprocket       15
Valve cover repainted with new breather gasket installed and new valve cover gasket    40
New EBC clutch and springs         75
Seat (recovered)      Make offer
Fuel tank (comes with petcock, new petcock gasket, gas cap with key, has surface rust on inside but nothing major)
Would like to sell with the side panels, front mudguard, and rear filler panel since they were all repainted the same color on top.      220 for panels, tank, and guard
Frame with title (includes rear sub frame)    Make offer
1992 Motor freshly painted (includes unpainted sandblasted stator cover, oil pan, new oil filter, new oil filter, new filter o ring, new exhaust gaskets and intake carb boot gaskets)    Make offer

I also have a lot of other misc. items such as oem intake box with K&N drop in filter, throttle tube, engine harness, good condition rpm gauge, black & yellow side panels, clutch lever, brake lever with master cylinder, sand blasted rear grab rail, new cables ( throttle, choke, etc.) if you don't see it just ask      All of those things are OBO.

Thanks for looking

[Kella]

You have a pm on your tank, and bodywork

[lucky4034]

PMed on sprocket and pegs

[rock_rebel]

Just curious on the headlight shipped to Canada?

[jdoorn14]

You don't happen to have one of airbrush's rear huggers, do you?

[milezero5]

No  def. No rear hugger    these plastics were painted by a friend of mine when i worked at nissan

Pms answered

[skudman]

I need that guy in the middle,below the plugs. Goes to the bottom of the fuel tank, while removing one of my lines the brass "nipple"? pulled out with the hose. Bikebandit calls it the Fuel chicken assembly.

I might be interested in that R6 shock, and SS brake line aswell, maybe we can work a deal.

[bombsquad83]

You can just press that nipple back in with a rubber mallet. I've done it twice with mine... Sorry to OP for thread jack.

[dirtynailz]

PM on the carbs

[GI_JO_NATHAN]

if you don't see it just ask 

Thanks for looking

Do you have a set of stock handle bars laying around?

[milezero5]

No sorry   no stock handlebars    pms replied   lmk if they didnt go through

[GI_JO_NATHAN]

No sorry   no stock handlebars    pms replied   lmk if they didnt go through

Cool. Thanks.

[rhebb]

Hi   I may Be interested in Your Tank, Fender + rear fairing.  (Painted Parts)     Can I get Shipping costs to Canada  Postal Code  S7M-1T3   Thanks  RHebb

[AC2B]

I'm interested in the V&H exhaust.

Do you know how much it would cost to ship to OH? 44107 specifically?

[05-500_F-aster]

I was wondering if by chance you would be willing to part with that sandblasted case cover (white)http://i805.photobucket.com/albums/yy339/milezero5/DSC00326.jpg? I imagine you wouldn't but it's worth a shot thanks

[cbcanada]

i am interested in tank and panels

[Big Rich]

Email sent on the K&N lunchbox filter.

[red rider]

Im interested in the tank and those handle bars...do i have to buy the tank and fender or just the tank...and do u have a front wind screen?

[milezero5]

Make me an offer on what you are interested

Sorry no windscreen

[red rider]

Not sure what to even offer....what's the tank condition?....and are those handlebars giona bolt right up on a 1999 s :woohoo:tock 500e