RU-0800

[BadBatzMaru]

was it easy to get the whole assembly back into the bike?  What did you do for the breather hose from the crankcase?

Jake,
wasn't so easy as getting the pod on the carbs itself.. kind of have to come in at an angle and then push the filter/carb assy into place... the pod is a snug fit side to side... this is why its easier to install it with the carbs off of the bike... its doable though.... not tough to do... and for the breather hose I got a one way valve PCV i think (found out about it by searching threads here) and a small filter... attached those at the end of some tube and routed it down...

good luck

[GRU]

yeah, the reason i had a hard time was because i didn't have my carbs off the bike, i just loosend the clamps and pulled the carbs a little but the cables wouldn't let me get the carbs out of the frame...i didn't use a pcv valve, but a crankcase breather from wal-mart  :mrgreen: