News:

New Wiki available at http://wiki.gstwins.com -Check it out or contribute today!

Main Menu

What would be the symptoms of leaky boots...

Started by seamax, April 26, 2004, 05:32:42 PM

Previous topic - Next topic

seamax


MarkusN

Don't know the exact symptoms, but to diagnose it, have the engine run in idle and spray a little brake cleaner on the boots. (Attention! highly flammable!) If you notice a change in rpm, the engine has sucked in the good stuff through the boots.

Woz

GS500E K2

scratch

Engine will run lean, usually accompanied by excessive heat and flakey rpm's. Slow to idle down. Or idle will hang at a higher rpm.
The motorcycle is no longer the hobby, the skill has become the hobby.

Power does not compare to skill.  What good is power without the skill to use it?

QuoteOriginally posted by Wintermute on BayAreaRidersForum.com
good judgement trumps good skills every time.

mwdbruno

Quote from: WozI was gonna say........ wet feet  :P

Glad to see I'm not th eonly one with a bad sense of humor (I thought the exact same thing!)   :lol:
_______________________________________
"Respect my authoriti!!"  Eric Cartman
______________________________________

JLKasper

WD-40 is less volatile than brake cleaner and more viscous.  It'll seal up any leak longer than something thin like contact, choke, or brake cleaner. :cheers:
"A skittish motor-bike with a touch of blood in it is better than all the riding animals on Earth."
               --T.E. Lawrence

glenn9171

Quote from: mwdbruno
Quote from: WozI was gonna say........ wet feet  :P

Glad to see I'm not th eonly one with a bad sense of humor (I thought the exact same thing!)   :lol:
Me too.   :lol:


(Woohoo!  900 posts for me.) :mrgreen:

MarkusN

Quote from: JLKasperWD-40 is less volatile than brake cleaner and more viscous.  It'll seal up any leak longer than something thin like contact, choke, or brake cleaner. :cheers:
AFAIK you don't spray the stuff there to seal the boots (as typical problems of leaky boots are intermittent anyway), but to get the stuff sucked inside and burned, thus affecting RPM. But WD-40 should do the same trick, as it also contains quite volatile, highly frlammable components.

freakaccident

I suggest spraying the brake cleaner into a straw and using the straw to drip it onto the sealed area.  Less dangerous and it will still get sucked in if there is a leak.  If you can't get a positive yes or no then just take the carbs off and replace the gaskets.

SMF spam blocked by CleanTalk