I drilled the baffle out in the can, the GS sounds awesome!!

[WAP]

I just did this mod last week, simply because I had nothing else to do friday afternoon, and i'm very happy with the results. I stopped at four holes, because that was loud enough for me (perhaps even a bit TOO loud for my tastes). The best part about this mod is that clean-up is a snap. Just switch on the engine, and let 'er rip! ....just make sure there's nothing behind the pipe that you don't want covered in metal shavings.  

[Frost]

anyone have pics of the actual pipe yet?

[ACE]

PICS REALLY ARENT NEEDED. the whole thing from start to finish took about 20-30 minutes. i will make a new topic titled, HOW TO: drill the baffle out. check it out.

[notoriouskeef]

My exhaust is gutted.  I got nothing in it.  Everything is stripped out. and I think it sounds awesome! loud as heck too.  So what if there is a performance loss who cares, we didn't buy our bikes for the performance, at least I didn't.  It's fast enough for me already.  

I'll try and take some pics of it tomorrow!

Matt

[yamahonkawazuki]

i took a 3/8" drill bit, 3 holes at even intervals to outside baffel (spelling?),
and an almost 1/2 in puch to the inner baffel.has a harley'ish idle note to it, but once opened up, thing sounds evil , also ended up putting on k&n pod, and 140mains into her, along with 37.5 pilots (stock?), with 2.5 turns out on screws. runs like a raped ape :mrgreen: total cost, 43 for everything,    :dunno:

[jdiggity]

how the heck do you get the inner, small pipe out?