Author Topic: Indicative Re-jetting matrix  (Read 20365 times)

Offline Lars

  • AMA Superbike Racer
  • ****
  • Posts: 401
  • Karma: +0/-0
Indicative Re-jetting matrix
« Reply #20 on: October 06, 2003, 09:06:04 AM »
1993 GS500E: Stock airfilter, stock exhaust, mixture screw 2,75 turns out, needle: needleclip 1 position higher than standard (~ 1 mm) , pilot jet:40, main jet: 125.

The jetting is exactly right at sea-level. Plugs are nice brown color.  
Jetting gets definitely rich when in the mountains. (1 km above sea-level)  Idle drops 300 rpm,  bike gets noticably slower. Luckily Holland is all flat, so always optimum mixture :)

Top speed: 185 km/h (flat on the tank, helmet almost resting on tach :P)

Offline Briggs

  • Formula Extreme Racer
  • ***
  • Posts: 233
  • Karma: +0/-0
    • http://www.wiskate.com
Indicative Re-jetting matrix
« Reply #21 on: October 06, 2003, 10:44:57 AM »
I got my 40s in this weekend. I will be installing them tonight, and after  I will let everyone know my results.
1989' GS500 - V&H Exhaust, K&N Pod, 137.5, 40, no washers
89' GSX-R rear rim, 150/60, and Katana shock

Offline conradvr

  • AMA Supersport Racer
  • **
  • Posts: 149
  • Karma: +0/-0
Indicative Re-jetting matrix
« Reply #22 on: October 06, 2003, 05:11:32 PM »
--------------------------------------------------------------------------------

Update : 4 (WHERE are the post 2001 riders???  please post your combinations, I will keep updating the table and finally this will be posted kindly by miket on his wesite for future generations - and future jetting questions can be easily referred to his site - saving newbies like myself spending hours searching)
--------------------------------------------------------------------------------


Air Filter: (s) - Stock Air Box, (p) - Pod replacement for Stock Air Box

Exhaust: Perf - aftermarket performance pipe, V&H - performance pipe, (s) - slip on, (f) - full system

Kit: Fac1 - Factory Pro Stage 1, Dyn1 - Dyno tune Stage 1, K&N1 - K&N Stage 1, Fac3 - Factory Pro Stage 3, Dyn3 - Dyno tune Stage 3, K&N3 - K&N Stage 3

Note (result, no of users): r- rich, sr - slightly rich, p - perfect, l - lean, sl - sligtly lean

Pre 2001
Exhaust.......|.Air Filter.|.Pilot.....|.Main.........|.#4Washers..|.Turns.|Note
..................|..............|............|.................|..or Kit.........|..........|
1...Stock.....|Stock......|40.........|125...........|1................|3........|p,1
2...Stock.....|UniF(s)....|40.........|125...........|1................|3........|
3...Stock.....|K&N(s)....|40.........|127.5........|2................|3........|
4...Stock.....|UniF(p)....|40.........|................|..................|.........|
5...Stock.....|K&N(p)....|40.........|147.5........|2................|2.5.....|p,1
6...Perf.......|Stock.......|40.........|................|.................|..........|
7...Perf.......|UniF(s).....|40.........|................|.................|..........|
8...Perf.......|K&N(s).....|40.........|................|.................|..........|
9...Perf.......|UniF(p).....|40.........|................|.................|..........|
10.Perf.......|K&N(p).....|40.........|140 - 150...|2...............|3 - 3.5|
11.Perf.......|K&N(p).....|40.........|140 - 150...|K&N3.........|3 - 3.5|
12.V&H(f)...|UniF(s).....|40.........|127.5.........|2...............|3.......|sr,1
13.SV650(s)|UniF(p).....|40.........|135...........|1...............|3........|
14.V&H(s)...|K&N(p).....|40.........|150...........|2...............|3........|p,1


Post 2001
Exhaust.....|.Air Filter.....|.Pilot.....|.Main.........|.#4Washers..|.Turns|Note
................|..................|............|.................|..or Kit.........|.........|
1...Stock...|Stock..........|............|.................|...................|.........|

Offline mjm

  • AMA Superbike Racer
  • ****
  • Posts: 400
  • Karma: +0/-0
Indicative Re-jetting matrix
« Reply #23 on: October 06, 2003, 05:40:22 PM »
Quote from: conradvr
--------------------------------------------------------------------------------

Update : 4 (WHERE are the post 2001 riders???  please post your combinations, I will keep updating the table and finally this will be posted kindly by miket on his wesite for future generations - and future jetting questions can be easily referred to his site - saving newbies like myself spending hours searching)
--------------------------------------------------------------------------------

I have had a couple different set-ups on a 2001.

Stock air filter and stock exhaust -  two washers 3+ turns on mixture screws and 135 mains - started a little better, more power but still took forever to warm up and popped and bucked while warming up.

K&N Pods, stock exhaust - #20 pilots, 3 turns, two washers, 142.5 mains - much better warm up and power.

K&N Pods, Cobra F1R - # 20 pilots, 3 turns, 1 washer, 150 mains - also tried 152.5 but was running rich on very hot days.

Starts without the choke in warm weather (70 degrees F and up) indicating that it may be a bit rich down low.  When it is cold enough to need the choke - warm up, to where it will pull without hesitation with the choke off, is about 15 - 30 seconds unless the temperature is below 40 degrees F -  then it may take a block or two.  Below freezing (like it was here this morning) I take the car.

Never touched the "mid-main"

Offline Adam R

  • AMA Superbike Racer
  • ****
  • Posts: 723
  • Karma: +0/-0
Indicative Re-jetting matrix
« Reply #24 on: October 21, 2003, 01:54:01 AM »
I'm running Vance & Hines exhaust, 150 mains, 40 pilots and K&N pod filters with the mixture screws at 3 turns out.  I think the idle is a little lean, so I'll try turning the mixture screws out a little more.  I haven't checked the plugs yet but the bike accelerates strongly through the rpms with no bogs or hesitations.


Adam
Current bikes:
1993 Honda NSR 250 SP
1994 Suzuki RGV 250 RR SP
1993 Yamaha Seca II

Offline Michael

  • World Supersport Racer
  • *****
  • Posts: 817
  • Karma: +0/-0
Indicative Re-jetting matrix
« Reply #25 on: October 21, 2003, 02:06:57 AM »
I put this on another post but will repeat it here to keep it all together.
2001, 27 000 km, running 91 octane, Uni in the box, Performance pipe (stock header diameter, 53.5mm collector and muffler inlet, less restrictive but still legal muffler), V&H advancer.
22.5 Pilots, screws 2 1/2 turns.  Needles FactoryPro Stage 1 with clips on second top slot.  127.5 mains.
Fuel consumption about the same as stock.  Maybe slightly rich (based on colour of muffler outlet only) but not bad.
"They that can give up essential liberty to obtain a little temporary safety deserve neither liberty nor safety." Benjamin Franklin

Offline miket

  • AMA Superbike Racer
  • ****
  • Posts: 429
  • Karma: +0/-0
    • http://www.angelfire.lycos.com/mt2/mikesgs500
Indicative Re-jetting matrix
« Reply #26 on: November 03, 2003, 08:58:50 PM »
I finally managed to put it on my web site. The URL is http://www.angelfire.com/mt2/mikesgs500/rejetting/Rejetting_Matrix.html
93' Red/Pink Disco-Mania

Offline JohNLA

  • Cheap Bastard
  • World Superbike Racer
  • *****
  • Posts: 1772
  • Karma: +0/-0
    • http://johnla2.tripod.com/
Indicative Re-jetting matrix
« Reply #27 on: November 03, 2003, 10:52:33 PM »
Thanks Mike, and nice job :thumb:
On his tombstone were the words "I told you I was sick!"

http://johnla2.tripod.com/

 

SMF spam blocked by CleanTalk