I just put on a set of srinath 2 weld bars and I am having a problem with the throttle grip. It is way too tight on the bar. It doesn't snap back after I roll off the throttle. Does anyone have a suggestion to fix this? I was thinking of buying some snadpaper and sanding the blcak powder coat off, but I don't know if that will make it more prone to rust. Any ideas? :dunno:
Quote from: nemesis109I just put on a set of srinath 2 weld bars and I am having a problem with the throttle grip. It is way too tight on the bar. It doesn't snap back after I roll off the throttle. Does anyone have a suggestion to fix this? I was thinking of buying some snadpaper and sanding the blcak powder coat off, but I don't know if that will make it more prone to rust. Any ideas? :dunno:
I believe that Srinath suggested sanding down the powder coat - powdercoat is very thick. Before sanding you might try a thin layer of grease under/inside the throttle tube. If that did not work, I think I would sand to bare metal and then put a thin coat of primer on that part of the bar.
Yep the sandpaper worked. Didn't even have to sand it all the way down to the bare metal.