Text only | Text with Images

GStwin.com GS500 Message Forum

Main Area => General GS500 Discussion => Topic started by: dgyver on February 24, 2005, 07:21:27 AM

Title: SV hugger does not fit (w/ teaser pic)
Post by: dgyver on February 24, 2005, 07:21:27 AM
I was told by JamesG that the SV hugger would fit with some trimming. After making a part, there is way too much trimming to do. Plus it is too wide and it would not look right on the SV. I plan on making another SV hugger out of fiberglass and cut it up to make the master for the GS.

Here is a teaser of the first attempt of the SV hugger that I made this week:

(http://img.photobucket.com/albums/v64/dgyver/BodyWork/SVhugger01.jpg)
Title: SV hugger does not fit (w/ teaser pic)
Post by: Jake D on February 24, 2005, 07:53:32 AM
Do it. . . Do it!  

Do it!!  

I'll pay.  No care how much. . .
Title: SV hugger does not fit (w/ teaser pic)
Post by: pantablo on February 24, 2005, 10:46:26 AM
Its a well known fact (except to you and jamesG apparently) that the sv hugger doesnt work. Better to use a bandit 400 hugger-less trimming and set up for narrower tire already.
Title: SV hugger does not fit (w/ teaser pic)
Post by: stefman722 on February 24, 2005, 11:38:00 AM
Quote from: Jake DDo it. . . Do it!  

Do it!!  

I'll pay.  No care how much. . .


x2
Text only | Text with Images