anyone have this set up? what jet settings did you decide works best?
bump
150/40/3/1.
Cool.
Srinath.
150 mains, 40 pilots, 3 turns out and 1 washer under the needle?
Quote from: weaselnoze150 mains, 40 pilots, 3 turns out and 1 washer under the needle?
Yup ... AKA "the usual"
Cool.
Srinath.
Hey would this be the same if you had a 15T sprocket, wielyco exhaust, K&N pods?
thanks! that was painless. i figured i would get a few, "search the damn forum" comments first. yea yea i know its just there's a lot of muck to comb through.
Quote from: gs500fpowerHey would this be the same if you had a 15T sprocket, wielyco exhaust, K&N pods?
Is this a trick question ... :? :? :? ...
OK then try this ... A cat chokes to death on a dead mouse ... so Who killed who ???
Yea same thing ...
Add a fringe ... still 150/40/3/1 ....
Oh yea ... use the search function ... :lol: :lol: :lol:
Cool.
Srinath.
one more for u srinny. u just said 1 washer. i just stumbled over this (http://gstwins.com/forum/viewtopic.php?t=12929). it says 2 washers? [/url]
Its pretty much a starting point ... my bet is ... mains and pilots will not need touching ... obviously ... the air screw and needle are adjust to taste .. I coinsider them external ... OK not external external ... but you dont have to take carbs off to get at any of them ... screws are external, needles need tank removal and tops off the carbs ... close enough ... so 2 washers OK ... usually 1 busome have 2 ... maybe the CA carbs need that extra washer and an extra turn of mix screw cos they take in more air via 1 size larger air jets ...
Cool.
Srinath.
on bikebandit.com the mikuni mains come in different shapes. do i get the hex type? http://www.bikebandit.com/partsbandit/productlist~section_dept_id~1170244~terrain_dept_id~1183501~cat_dept_id~1230868~product_dept_id~1231067~selection_Path~3.asp
also i should get 2 mains and 2 pilots right?
large round slotted ... BTW its 89-00 right ??? else you're going to have to check the FAQ ...
Cool.
Srinath.
yes '00. but 2mains 2 pilots? and what shape pilots?
Non bleed pilots ... if your delaer gives you crap, or acts like they dont exist and you're the Idiot ... get it from me ... $20 shipped ... instant shipping too ... in under 12 hours .. :lol: I have it all ready to go ...
Cool.
Srinath.
is the 20.00 for mains and pilots ?
Its for 2 mains (125 or 150), 2 pilots, 2 washers - OK if you want 4 washers ... and 4 allen bolts for the float bowls. AKA all you'll need ... add $7 if you want stage 1 and 3 ... so you'd get 2 of 125's and 2 of 150's ...
Cool.
Srinath.
i've got two washers under my needles on my '93 with a wileyco and lunchbox and i think it runs a bit rich. haven't checked the plugs lately, but it was running rich after i first finished the rejet. i bet you'd be fine with just one washer under the needle. matter of fact, i may remove one and let you know the results.