what would be the best way to gut a stock exhaust canister?
Im assuming you would have to cut it down the middle and re weld it, but y go through the trouble just get a wiley co ;)
You can in theory cut it at the point where the headers flare out into the can and use a hole saw and get rid of the 2 layers of baffles and pretty much empty the inside out for a good 2 inch dia down the center and weld it back ... OK never tried it ...
Cool.
Srinath.
you can cut the end off, gut it, then cap it.
Quote from: JetSwingyou can cut the end off, gut it, then cap it.
ya that is the best thing going so far i think
Edit;
cheap to
just a few cuts a weld or two. for the price of a little flux, a can o spray, and if the welds are for some odd reason beond my ability a case of beer for a friend of mine
( NOTE TO SELF: {quality control} do
NOT give him the beer untill he is done.)