GStwin.com GS500 Message Forum

Main Area => General GS500 Discussion => Topic started by: mdbHokie on June 10, 2006, 02:29:37 PM

Title: Idle Adjustment not working?
Post by: mdbHokie on June 10, 2006, 02:29:37 PM
I can't seem to get my bike to idle below 1500-1700 rpm.  I've been messing with the idle adjustment knob for a while and the idle will never go down no matter how much I loosen it.  I can get the idle to slightly increase by tightening the screw, but that's about it.  If the screw is too loose, will this cause problems?

Any ideas what could be causing this?  It's an '04 GS500F and has around 750 miles on it.  I just got it last weekend (600 miles then) and had the 600 mile service done at the beginning of last week.

Mike
Title: Re: Idle Adjustment not working?
Post by: hmmmnz on June 10, 2006, 02:54:25 PM
check the cable adjustment, you may have it caught on some thing,
Title: Re: Idle Adjustment not working?
Post by: mdbHokie on June 10, 2006, 03:02:13 PM
Quote from: hmmmnz on June 10, 2006, 02:54:25 PM
check the cable adjustment, you may have it caught on some thing,

which cable... throttle cable?  It might be too tight.  I notice that when I turn the handle bars to full lock right the idle increases to 3000 rpm.  I don't know how to adjust the throttle though.
Title: Re: Idle Adjustment not working?
Post by: scratch on June 10, 2006, 04:53:20 PM
You'll need to add some slack to your throttle cable:
http://gstwins.com/gsboard/index.php?topic=26977.msg284347#msg284347
Title: Re: Idle Adjustment not working?
Post by: mdbHokie on June 10, 2006, 05:07:37 PM
Yep... it was the throttle cable.  I looked in my manual and found instructions for adjusting it.  After adjusting the cable, I went for a 10 minute ride and then adjusted the idle.  Everything is much better now.  Thanks guys!