Text only | Text with Images

GStwin.com GS500 Message Forum

Main Area => General GS500 Discussion => Topic started by: TadMC on June 22, 2006, 05:47:37 PM

Title: Can SM2 bars be machined easily.
Post by: TadMC on June 22, 2006, 05:47:37 PM
Tommorrow, I was thinking of going to maching shop and getting em to make me some.

I would need some measurements, but could this be done.... easily and safely
Title: Re: Can SM2 bars be machined easily.
Post by: Alphamazing on June 22, 2006, 06:07:41 PM
http://gstwins.com/gsboard/index.php?topic=27139.0
Title: Re: Can SM2 bars be machined easily.
Post by: TadMC on June 22, 2006, 06:21:29 PM
Is there a way to get rid of the bar ends.  also, whats the diameter of the sm2 bars
Title: Re: Can SM2 bars be machined easily.
Post by: Alphamazing on June 22, 2006, 06:22:17 PM
Quote from: TadMC on June 22, 2006, 06:21:29 PM
Is there a way to get rid of the bar ends.  also, whats the diameter of the sm2 bars

bar ends are just an expansion rubber type. Just take them out. 7/8" diameter.
Title: Re: Can SM2 bars be machined easily.
Post by: The Buddha on June 22, 2006, 06:55:27 PM
They are welded more than machined.
I will start making steel ones in a bit ... yea yea I know ... forever ... right ...
Cool.
Srinath.
Title: Re: Can SM2 bars be machined easily.
Post by: average on June 22, 2006, 11:33:34 PM
lol
Text only | Text with Images