Print Page - srinath I need your help

Title: srinath I need your help
Post by: mach1 on June 22, 2007, 09:23:33 PM

http://cgi.ebay.com/ebaymotors/Honda-CBR600F4i-Tail-CBR600-F4i-CBR-600F4i-Rear-Cowl_W0QQcmdZViewItemQQcategoryZ35583QQihZ018QQitemZ280126933793QQrdZ1QQsspagenameZWDVW
How much work would I have to do as far as the cowls go and both seats?

Title: Re: how hard to make this fit a GS
Post by: genEricStL on June 22, 2007, 10:23:57 PM

I myself dunno but it would look bad-arsed bro ... good luck , and make sure to show it off if you get it and get it installed :thumb:

Title: Re: how hard to make this fit a GS
Post by: annguyen1981 on June 22, 2007, 10:32:51 PM

The "easiest" way would be to cut off the GS subframe. Then weld the F4i subframe to the GS frame...

The only problem would be the fitment between the seat and the tank.

Title: Re: how hard to make this fit a GS
Post by: blue05twin on June 22, 2007, 10:44:21 PM

Ditto think you whould have to get the whole sub frame. I think Sinrath did it once. . or was thinking about it. . .I'm old and forget things

Title: Re: how hard to make this fit a GS
Post by: mach1 on June 23, 2007, 08:53:42 AM

Hey Srinath can you give me some assistance please.

Title: Re: srinath I need your help
Post by: mach1 on June 23, 2007, 06:39:19 PM

oh yeah and some pics if yah got any

Title: Re: srinath I need your help
Post by: The Buddha on June 23, 2007, 07:06:21 PM

OK I never have done this, I've just sat the tail section on my frame, worse yet, my tail is the one (Maybe F4 not F4 I ) that has a single seat ... or this clown is lying about this ... cos there is a wrecked F4I with a tail like mine ...
So, no clue, but at least, it doesn't look like this tail.
Cool.
Srinath.

GStwin.com GS500 Message Forum

Main Area => General GS500 Discussion => Topic started by: mach1 on June 22, 2007, 09:23:33 PM