Can the inside of the stock handlebars be removed? Can they pop out, and if so, how?
Thanks
-k
EDIT: 9s500e '94
drill them, but just beware that lighter ends will increase vibration
Right. I had thought of that but didn't want to go that far.
if you look you will see that they are spot welded in there
ack. Okie. Thanks a bunch :)
I dont think you can drill them out, unless you have some pretty awesome drill bits.. I tried and got no where... I just got new bars :thumb:
Put a screw in the threads, tie it to a string, pull the string through a small piece of pipe or a small socket, SMACK it with a hammer twice. viola, pull out the slug.
I mean, that's how I did it.
when i put the 89 triple and clip ons on my F model i took the stock bars put them in a vice and went at them with a drill. eventually i got them out and put in the standard bar ends with the rubber ends. to be honest they did not seem that secure. i have the same light alum bar ends on my bike and they have yet to fail
Just a thought, those bar ends should do a good job of preventing the naked end of the handle bars stabbing through your soft mid section in the event of a crash.
Fond memories of -not- being stabbed through the mid section by a mountain bike handle bar come to mind...