currently
stock exhaust
foam filter
125/40 with 2 washers
currently at 2.5 turns out on the screw
does that seam right?
is each bike a bit different, someay they have 3.5 turns some 3
also when i twist the throttle, it appear to stumble for a milli-second
can this be improved, shoudl i be at 3 turns out exactly
carbs have been synched!
I believe I have the same setup as you.
Stock can, UNI foam filter. I am running 125/40's and 3 turns out. with 1 washer. I would try turning your screws out that 1/2 turn and see if it helps. :thumb:
dont worry about the washers. They only affect mid-range.
It is under no load?? well check float levels...They should be right at the top of the bowl and the 2 should be equal. How is it under load. How are the plugs. I believe you are dealing with a small differential between the 2 in their settings.
Cool.
Srinath.