I got a slipon for real cheap; however on the wiki...the midpipe section looks a bit different. where it would connect to the header, it has a little crook/bend which throws the muffler at some extreme angle.
(http://img.photobucket.com/albums/v260/kelieo/exhaust009.jpg)
i am going to go to the muffler shop and they can probably cut and rotate that section to make it fit well, however was there a way to mount this up?
wiki says:
1. Cut and reweld the link pipe to get the right angle
2. Get a couple of washers and force the can outwards to clear the swing arm
number two would make it impossible to mate it to the header, i would need a ~150° flared pipe to make it work
i searched but never found a definitive answer to how to mount this or close up pictures showing modification.
obviously an exhaust shop can take care of this, but i'm not sure i trust any places in my area
Yea exhaust shop can cut and weld the mid pipe. About the only option.
Cool.
Buddha.