GStwin.com GS500 Message Forum

Main Area => General GS500 Discussion => Topic started by: jrains89 on October 14, 2008, 04:21:48 PM

Title: Trying to get it running tight.
Post by: jrains89 on October 14, 2008, 04:21:48 PM
So I just got a 2004 gs500f, a kid wrecked it with only 256 miles on it, and it probably sat in an insurance lot for a long time. I started it to make sure it ran, and put it in every gear so that's good, but it doesn't idle well at all. I know there should be a warm up period, but the idle floats around alot, i started it with full choke and it would flutter between 3k and 4k, and if i tried to give it any gas it would die. I searched but didn't think any results were really applicable here. what are the first things i should check and/or do? thanks.
Title: Re: Trying to get it running tight.
Post by: commuterdude on October 14, 2008, 05:41:36 PM
pull the carb jets and clean, check your float heights, clean all and re install.  Lots of how to's here or on the wiki.
Title: Re: Trying to get it running tight.
Post by: LOUiE on October 14, 2008, 06:21:00 PM
+1 clean & set carbs
Title: Re: Trying to get it running tight.
Post by: Chanse on October 15, 2008, 07:00:35 AM
make sure no vacume leaks or the carbs didnt take a jar and loosen the intake boots also. +1 on the carbs and float height. Oh and throtle cable. if it was front end damage.