Tearing my carbs apart and I noticed something funky with the valve piston. It's been drilled and I plastic insert has been inserted on one side of the needle.
(http://img23.imageshack.us/img23/3171/0417091925.jpg) (http://img23.imageshack.us/my.php?image=0417091925.jpg)
Obviously, this is causing problems. Does anyone know the diameter of the holes from the factory? These little bastards are expensive and I don't want to have to buy new ones.
Not 100% sure but the PO may have rejetted the carbs with a Dynojet kit that requires drilling holes in the slide.
Yeah I thinks thats the case. Now I gotta figure out if I get get it to run right with the new jet's that I'm running
I think you should talk to Buddha. he is carb guru here and he might have some spare, not drilled, slides. good luck
Good thinking, I sent him a message.