Print Page - help identifying parts

Title: help identifying parts
Post by: flair.14 on May 28, 2009, 01:28:24 PM

I need help identifying 2 parts for the engine. I snapped 2 photos of each part...

(http://i578.photobucket.com/albums/ss230/flair14/IMG_4225.jpg)

(http://i578.photobucket.com/albums/ss230/flair14/IMG_4224.jpg)

(http://i578.photobucket.com/albums/ss230/flair14/IMG_4226-1.jpg)

(http://i578.photobucket.com/albums/ss230/flair14/IMG_4227-1.jpg)

Does the second part do inside the shaft which holds the clutch housing?

Title: Re: help identifying parts
Post by: utgunslinger13 on May 28, 2009, 01:30:26 PM

I'm not sure about the second one, but the first looks like an oil pressure sensor?

Nick

Title: Re: help identifying parts
Post by: flair.14 on May 28, 2009, 03:35:18 PM

Thank you very much. The first item is indeed the oil pressure sensor.

Now if I could only figure out what is the first item :icon_question:

Title: Re: help identifying parts
Post by: utgunslinger13 on May 28, 2009, 04:20:44 PM

Where did it come from? I can't tell if you removed it from something on the bike of if you bought something and it came with it?

Title: Re: help identifying parts
Post by: flair.14 on May 28, 2009, 04:53:59 PM

I think it came from the engine but I cannot remember... It seemed to have some from one of the shafts. I am guessing the shaft that holds the clutch housing but I am not sure.

Title: Re: help identifying parts
Post by: simoniz on May 28, 2009, 06:11:42 PM

Clutch push rod shaft? Just a guess. Check the online parts fiche at RonAyers or BikeBandit.

Title: Re: help identifying parts
Post by: joshr08 on May 28, 2009, 06:47:14 PM

it is a CLUTCH PUSH ROD

http://www.bikebandit.com/suzuki-motorcycle-gs500el-1990-clutch/o/m6050sch247267

#19

Title: Re: help identifying parts
Post by: average on May 28, 2009, 10:41:57 PM

Just replaced the smaller pushrod on the leftside and I had to remove that one to get the other broken piece out. Since you're in there, go ahead and order a new oil seal so you don't have to replace it later.... :whisper:

GStwin.com GS500 Message Forum

Main Area => General GS500 Discussion => Topic started by: flair.14 on May 28, 2009, 01:28:24 PM