Print Page - Dumb question, but how do you remove the pegs?

Title: Dumb question, but how do you remove the pegs?
Post by: gsf500RR on October 27, 2009, 10:53:11 AM

:dunno_white: I have try my smallest wrench key (7) and it did not catch the screw, what tool are you suppose to use?

Title: Re: Dumb question, but how do you remove the pegs?
Post by: redhenracing2 on October 27, 2009, 10:55:21 AM

mine just have a little pin going through that is held in by a circlip. using a hex wrench would do absolutely nothing for it, unless yours are different than mine

Title: Re: Dumb question, but how do you remove the pegs?
Post by: gregvhen on October 27, 2009, 11:02:10 AM

get a flat head and take the clip on the bottom off. watch out though, it may very easily shoot off and get lost. then just slide the pin out.

Title: Re: Dumb question, but how do you remove the pegs?
Post by: mitch.lax on October 28, 2009, 06:39:22 PM

ditto, pry out the circlip, but watch where it goes, or hold a hand underneath. I lost one of mine for a good 15 minutes of looking once.

GStwin.com GS500 Message Forum

Main Area => General GS500 Discussion => Topic started by: gsf500RR on October 27, 2009, 10:53:11 AM