I'm parting out my 92 GS500
Engine blew but the carbs and side cases are still good as is the rest of the bike.
I have the title for the frame but reg (in CA) is past due.
I've already sold my 90 GS and this one is next on the chop block
I need room in my garage to work on my firebird *insert mullet emoticon here*
post what parts you need and and an serious offer
(also have an 81 CB750 im parting out DOHC)
ignition rotor - $15 + shipping.
How is your gas tank? If decent then $50 + shipping. Pics?
Also, the handlebar turn signal switch, $10 + shipping.
Sending you a PM and an e-mail now...
noober
EDIT: Where in CA are you located? SoCal, NorCal, the Mojave... can you post your town or zipcode?
Thanks
Do you have that little piece of plastic under the grab bar that connects the 2 side fairings together? If so, how much shipped to zip code 21212? Thanks
-Jessie
Quote from: 007brendan on November 30, 2009, 12:38:28 AM
ignition rotor - $15 + shipping.
send the part official part number from like bike bandit to make sure you get the right parts! dont suppose you want to doa even 20 tho :cheers:
Quote from: nakedGS on November 30, 2009, 04:47:15 AM
How is your gas tank? If decent then $50 + shipping. Pics?
tank was dented by previous owner and bondo'd over it's got an okay shape but could use some proper paint as It's rattle canned now. i'll get pics soon.
never had any problems with it.
Quote from: nakedGS on November 30, 2009, 05:17:33 AM
Also, the handlebar turn signal switch, $10 + shipping.
sure!
Quote from: GSnoober on November 30, 2009, 05:19:54 AM
Sending you a PM and an e-mail now...
noober
EDIT: Where in CA are you located? SoCal, NorCal, the Mojave... can you post your town or zipcode?
Thanks
I'd like to keep the center and subframe cover together... but dont fret! if they dont sell its yours
Quote from: GSnoober on November 30, 2009, 05:19:54 AM
Sending you a PM and an e-mail now...
noober
EDIT: Where in CA are you located? SoCal, NorCal, the Mojave... can you post your town or zipcode?
Thanks
I'm in the nortbay (santa rosa) but I often goto San Fran
How's the gauge cluster on the bike? pics?
how much for igniton lock,gas lock shipped to 71270
Manoj
the tach needle is broken (but still in the housing you can have speedo and tach for 25$ +ship (just take the metal bit off and superglue)
I no longer have the tank/key for it
Is this bike is black in color, am interested in a front fender and rear grab bar. Thanks.
batglider@yahoo.com
front forks, rear wheel, rear axle + chain adjuster, front brake lever, right side handle bar controls with throttle tube, right side engine cover(the small circle one), swing arm for $200?
pm me and shipping would be to 90066 (if not close enough for pick up)
how is the headlight? how much would you want for it? and casing for the guage cluster if you still have it... :)
Quote from: jonjon on December 11, 2009, 10:55:29 PM
front forks, rear wheel, rear axle + chain adjuster, front brake lever, right side handle bar controls with throttle tube, right side engine cover(the small circle one), swing arm for $200?
pm me and shipping would be to 90066 (if not close enough for pick up)
at this moment i still have the forks adjusters all the controls.
dont have the swing arm or covers
shipping forks is pricy tho.
Hi there,
Actually, shipping forks is not too bad.
I've had a set of GS500 fork legs shipped to me and I've shipped a set out to someone else through the USPS.
Use one of the Priority Mail three-sided long tubes (they are free for Priority Mail customers). Wrap each leg in bubble wrap, put them inside the tube (put one leg in bottom first and the other leg in top first and they will both fit).
Shipping should be about $24 from east coast to west coast.
It works well.
Good luck.
Yours,
Trw
I saw someone made an offer on the front brake lever. Did that go through? I'm looking for the set of both levers, but it would depend on what kind of condition they were in as far as how much. I don't need the brackets that hold them on the bars or anything, just the actual silver part.
levers are both gone.
do you still have the guage cluster?
so could you do the forks and the throttle tube with the bar controls for $80 shipped? pm me
Carbs still available? Condition?
just sold the carbs =-P
does it have an aftermarket exhaust? if so what and how much?
sorry stock pipe.
pm sent
Do you have the part that I broke?
(http://i47.tinypic.com/f3vw61.jpg)
if so, let me know how much shipped to 30033
thanks!
Are the handlebars straight (and I mean perfectly straight ;) )?
Quote from: starshooter10 on November 29, 2009, 11:58:36 PM
I'm parting out my 92 GS500
Engine blew but the carbs and side cases are still good as is the rest of the bike.
I have the title for the frame but reg (in CA) is past due.
I've already sold my 90 GS and this one is next on the chop block
I need room in my garage to work on my firebird *insert mullet emoticon here*
post what parts you need and and an serious offer
(also have an 81 CB750 im parting out DOHC)
I need your starter relay.... right hand side... two heavy wires, one to starter, other to battery... see parts fiche here... i have another thread begging for a relay.... then noticed yours. Paypal + shipping in 2 minutes. :)
see here :
(http://www.bikebandit.com/assets/schematics/Suzuki/SU0083_023.gif)
Where did it blow? is the head still good? or at least the camshaft caps. buddha says you cant interchange the caps, but if youll sell em cheap im willing to try em. unless the whole head is in tact
do you have the clutch lever still? thanks!
James
I'd like to buy the plastic that's between the rear of the two side panels. Got it? Thanks!
5-10 bucks? Its small. Bike bandit doesnt have it thats the only reason im asking.
bump. got it? also depending on the color ill take the side panels.
is the right side small contact cover gone?
is the tank still available, if so any pics?