My gearchange level is too high to properly change gears. I want to adjust it, but I don't have the correct nut size. What is the size I need?
on mine its a 6mm allen head bolt.
i think its a 10mm bolt as standard.
10mm, a potential problem i ran into is the range of movement. the shifter moves 1 tooth at a time and each tooth is a huge change, I thought it was too high and adjusted it down 1 tooth. well that one tooth took the shifter way too far down so I ended up bending the lever a bit and its now perfect.
You need a 10mm spanner assuming the bolt is standard. Loosening it isnt enough, its a pinch-bolt so it needs to be completely removed before the lever will slide off the spline.
A tip is to mark the shaft end end relative to the lever by making a dot on each with a centerpunch before you take the lever off. Do this and you will always have a reference point to go back to
Are you on the lefel?