Print Page - Turn Signal Shaft Size

Title: Turn Signal Shaft Size
Post by: shawn on May 17, 2011, 05:34:38 PM

I am looking to pick up some aftermarket turn signals, but the ones I found come in two different shaft sizes, 7mm and 9mm, anyone know how big the stock ones are? I checked my Haynes manual and it doesn't say.

thanks
shawn

Title: Re: Turn Signal Shaft Size
Post by: werase643 on May 17, 2011, 05:48:50 PM

get the bigger ones

Title: Re: Turn Signal Shaft Size
Post by: sledge on May 18, 2011, 08:11:53 AM

Its easier to make a hole bigger than it is to make it smaller :D

Title: Re: Turn Signal Shaft Size
Post by: shawn on May 18, 2011, 10:52:19 AM

Quote from: sledge on May 18, 2011, 08:11:53 AM
Its easier to make a hole bigger than it is to make it smaller :D

Good point :)

thanks
shawn

Title: Re: Turn Signal Shaft Size
Post by: werase643 on May 18, 2011, 12:25:06 PM

i guess i could have said.... with the smaller shafts...you need to add 2 washers to get it to hold..... and then you add weight and a little ugly

GStwin.com GS500 Message Forum

Main Area => General GS500 Discussion => Topic started by: shawn on May 17, 2011, 05:34:38 PM