Print Page - how do you use a tap?

Title: how do you use a tap?
Post by: brandiwine on November 22, 2003, 07:52:48 PM

i'm installing the jynojet kit. how do i use the tap tool? the tool i have has a sorta drill bit feeling end with the other end being pointed and cut sorta like a philips head screw driver. the instructions just say to tap the holes i drilled, so can someone elaborate for me on how to use this too? thanks!

Title: how do you use a tap?
Post by: yamahonkawazuki on November 22, 2003, 09:44:50 PM

always must make sure the tap is going in straight. 1/4-1/2 turn in then back off repeat until finished. taps are fairly easy to use, if you've never used before, try on a junk piece first so you get the feel of it. :thumb:

Title: how do you use a tap?
Post by: brandiwine on November 22, 2003, 10:31:51 PM

thanks! all done. tomorrow will be judgement day!

:mrgreen:

GStwin.com GS500 Message Forum

Main Area => General GS500 Discussion => Topic started by: brandiwine on November 22, 2003, 07:52:48 PM