The local auto parts shops are out of gasket remover. Would brake fluid be a good alternative? I'm not worried about paint or contamination of oil in the crankcase. I have scrappers but some of the gasket is so fine its not scrapping. Any other options?
what gasket are you trying to remove? be careful and use a fine scotchbrite pad.
It's the right side crankcase cover. I'm am trying to be very careful thats why I want a gasket remover because its so fine the blade might damage the metal. someone said gas and a stiff wire brush.
Quote from: socialDK on September 10, 2011, 07:03:48 PM
It's the right side crankcase cover. I'm am trying to be very careful thats why I want a gasket remover because its so fine the blade might damage the metal. someone said gas and a stiff wire brush.
If you are worried about damaging metal a stiff wire brush is the last tool you want to use! If it gouges the mating surface it will cause an oil leak. You could use a razor blade and a lot of patience. I've never heard of using brake fluid so i can't give any opinion on that. Good luck :thumb:
-Jessie
Try sharpening your scraper, if you use your wire brush without too much brute force or even some relatively fine sandpaper like 320 grit just on the stubborn bits that should work fine.
fine scotchbrite is available at the hardware store and will grab and remove the gasket without scratching the metal.
Any proprietary brand of paint-stripper will break the gasket down and it WONT damage the metal. Just dab it on with a paintbrush and leave it to soak in but it goes without saying that you need to keep it off painted surfaces.