In November I will finally have some funds to put towards my bike.
I hate, hate the stock exhaust and want to change it out to the carbon fiber TRS.
MY question is I don't want to stay too far from the original setup from the factory so I am going to keep the stock air box, but does K&N have a filter that will drop into the airbox or should I just get a lunchbox filter?
yeah k&n has a drop in filter, check ebay you can get them a whole lot cheaper there man!
Stay with stock paper, a lot cleaner for your bike.
You said Yosh trs - but are you set on Carbon fiber ... I have a Ti one with a blemish in it but the clamp goes right on it, in fact that is the cause of the dimple, dime sized round one, I may try to open it and fix it one of these days.
If you want it 125 and ship, add in a jet kit for the setup for 20 and I'll ship en all in the same box. BTW this is a flanged can and it comes with a flange essentially you can fit it on and ride it to the welder and have them tack it. Or run a muffler clamp and dont tack it.
I actually also have new scorpion cans, but those are oval and I have Ti and ss, and those are slip on fit on a 01+ ...
Cool.
Buddha.
I think afterbooster has a couple K&N with out the restrictor.
You can call K&N to get that part.
Here you go:
Dear Patrick,
Thank you for your interest in K&N products. You can purchase part number 087018-1 by contacting our customer service department at 800-858-3333. If you have any further questions please feel free to ask.
Thank you for writing,