GStwin.com GS500 Message Forum

Main Area => General GS500 Discussion => Topic started by: error on July 03, 2012, 02:28:46 PM

Title: Gas in oil sump question
Post by: error on July 03, 2012, 02:28:46 PM
I've got a sticky float needle in my carb, that I realized a little late. A bit of gasoline went into my oil sump. Not much, I cut off the fuel supply as soon as I realized.

Question is.. can I just leave it alone? Maybe a half cup of gasoline at most got in. I just did an oil change before this and it wouldn't be fun to do another one.
Title: Re: Gas in oil sump question
Post by: adidasguy on July 03, 2012, 02:32:17 PM
#5021

Gas in oil is really bad. Since you just did an oil change, all you need to do is drain and re-fill. No need to replace the filter.

Are you sure gas went into the oil? How did it get in there? Does the oil smell of gas?
Title: Re: Gas in oil sump question
Post by: error on July 03, 2012, 02:34:02 PM
From what I read, if the carbs overflow some gas goes into the cylinders and seeps through the piston rings. Accurate? No idea. Oil has a slight gasoline smell to it.
Title: Re: Gas in oil sump question
Post by: adidasguy on July 03, 2012, 02:37:23 PM
#5022

That can happen.

Oil smelling of gasoline is always bad. Drain and put new oil in. Don't ride until you do it.
Title: Re: Gas in oil sump question
Post by: marc on July 03, 2012, 04:04:14 PM
Agree.
Drain oil and put new one.
Old oil can be used to lubricate chain or other parts.

Oil with gas will easily leak through gear lever and sprocket seal ruining your shoes.
Title: Re: Gas in oil sump question
Post by: ivany on July 03, 2012, 05:05:11 PM
Half a cup into a 3 qt sump is about 4% fuel dilution. While significant, lots of carbureted bikes run with 2-3% in their oil and that is considered normal. If you're convinced it was less than 1/2 of a cup (<4 oz) I wouldn't dump the oil just for this. The oil will slowly evaporate when the bike is hot so the problem will "fix itself".

How did you notice the oil was getting in?