Hey when i start the bike after its been sitting there for a few hours the taco does not show any revs till I tap it then it free's up. What can I do to fix this? Thanks
mmmmmmmmmmmmmm tacos.
unplug tach cable from engine, make sure it's lubed, reinstall making sure it's seated correctly.
What year bike?
Older have a cable tach, newer have an electronic tach.
I bet it's an older cable tach. Is your cable stuck/rusted?
What year bike?
Wrong! It's a 04F with electric tach. :icon_lol:
Wish everyone would get in the habit of telling us what year bike they are talking/inquiring about. Although very much the same for the 2 decades they've been making them, there are some very significant differences when getting down to details.
Neither my 97 or 02 GSs were equipped with tacos.
One of my 07s would stick every now and then. After cranking the revs or tapping the tach it would work. Its just a loose connection and IMO, no big deal.
It's an 04 gs500
So either tap on it or check your wiring. :icon_mrgreen:
Yeah if I tap it then its fine I just don't want it to get worse over time
You can take it apart and check the connections
Quote from: Jimbob on January 20, 2013, 04:14:30 PM
Yeah if I tap it then its fine I just don't want it to get worse over time
its not hard to work on, the electrical system on our beloved gs albeit simple, anyone can work on. can either check from the tach down, or from feed up. although what you were saying that it worked after tapping it, sounds like issue is close to tach
Check the wires on the back of the tach. Sounds like one is loose. 3 wires: +12, ground and signal. any one of them could be loose.
I'llcheck it out today cheers