Print Page - Front Upper Engine Mounting Bolt Diameter

Title: Front Upper Engine Mounting Bolt Diameter
Post by: NYNJ8 on April 21, 2015, 05:07:43 PM

Making some DIY frame sliders. Can anyone tell me diameter of the front engine mounting bolt? Its the long one with two long spacers. Thanks.

Title: Re: Front Upper Engine Mounting Bolt Diameter
Post by: Big Rich on April 21, 2015, 07:27:06 PM

10*255mm

Look on partzilla.com, and find the bolt you're looking for. If it is part #22 on the crankcase diagram, it lists the size in millimeters.

Title: Re: Front Upper Engine Mounting Bolt Diameter
Post by: NYNJ8 on April 21, 2015, 09:06:34 PM

Thanks Rich. I need to buy a longer threaded rod of the same diameter to thread through the mounting holes. Then I'll add the sliders, cut excess and cap and bolt the ends.

Couldn't find the stock bolt on partzilla. Is it listed at M10 diameter?

Title: Re: Front Upper Engine Mounting Bolt Diameter
Post by: gsJack on April 22, 2015, 05:24:21 AM

From another handy parts fiche:

22 BOLT 10X255 09103-10137

Should be 10 mm dia x 255 mm long.

http://www.shspowersports.com/fiche_section_detail.asp?section=300541&category=Motorcycles&make=SUZUKI&year=2004&fveh=7247

Title: Re: Front Upper Engine Mounting Bolt Diameter
Post by: NYNJ8 on April 22, 2015, 07:28:44 AM

Thanks guys I appreciate the help

GStwin.com GS500 Message Forum

Main Area => General GS500 Discussion => Topic started by: NYNJ8 on April 21, 2015, 05:07:43 PM