I've got a rebuild kit for the carbs and I'm trying to clean it all up and swap the o-rings.
When I pull out the Air/Fuel mixture screw i can get the spring to fall out but the washer and o-ring
stay in there.
Is there any method to getting those guys out? I think the hole is too small for an o-ring pick and I'm not
really sure what else to do.
Thanks
If you can't get it with a pick, try using a machine screw. I used to do that with paintball guns with tricky o-rings. Thread it into the o-ring, pull o-ring out, unthread o-ring off screw. As long as you have a fine thread screw that's just the right size it won't even damage the o-ring.