GStwin.com GS500 Message Forum

Main Area => General GS500 Discussion => Topic started by: Sahtlinurk on February 15, 2018, 02:07:09 PM

Title: Ticking noise ( video )
Post by: Sahtlinurk on February 15, 2018, 02:07:09 PM
Hi,

the noise comes and goes. What is that ticking?

https://youtu.be/RAHTFlBrFdA

cheers Lauri
Title: Re: Ticking noise ( video )
Post by: gregjet on February 16, 2018, 12:51:46 PM
It is possible that it is arcing from the plug leads/cap/plug but it soulds a little too lacking in the high frequencies. That could just be the lack of freq. response of the phone of course.
Other than that most likely the cam/followers/ valves.
I haven't heard the slack cam chain rattle on a gs so someone may recognize that if it is the noise..
Title: Re: Ticking noise ( video )
Post by: Sahtlinurk on February 18, 2018, 10:27:31 AM
 Measured the valve clearances today and noticed the cam chain was a bit slack. took the tensioner off, gave it a good clean and some wd40 on the spring and put it all back together.
will take her for a longer ride tomorrow to see how it will sound after it has  properly warmed up. 

cheers,
Lauri
Title: Re: Ticking noise ( video )
Post by: gregjet on February 18, 2018, 12:41:49 PM
WD40 is not  a lubricant. In fact it makes a cutting cutting fluid if you need one and haven't go anything else. It is an anticorrosion fluid. Ordinary oil would be a better thing to use especially as WD40 reduces the shear strength of any oil that is there until the oil can penetrate again.
Title: SOLVED Re: Ticking noise ( video )
Post by: Sahtlinurk on April 26, 2018, 01:41:17 PM
Sorted. It was cam chain noise . Auto tensioner was gone.
No more ticking after changing it. Interestingly it had the springiness
but at the very end of the travel it kind of a lost it and left the chain just little bit
loose.

Lauri