Text only | Text with Images

GStwin.com GS500 Message Forum

Main Area => General GS500 Discussion => Topic started by: b1k3r 3li+3 on April 24, 2004, 07:21:59 PM

Title: Vance & Hines A CBR900RR S4 TI Bolt-On?
Post by: b1k3r 3li+3 on April 24, 2004, 07:21:59 PM
I have a friend that can do my welding, but will this can work well with the gs with the subseqent rejetting of course
Title: Vance & Hines A CBR900RR S4 TI Bolt-On?
Post by: werase643 on April 24, 2004, 08:52:02 PM
no real need to re jet....might want to open the air bleeds an extra turn and shim the needles 1 mm

of course this is my oppinion of what i did when I installed a piece from a gsxr 600 pipe and a aftermarket can
Title: Vance & Hines A CBR900RR S4 TI Bolt-On?
Post by: RoundBall on April 25, 2004, 02:17:33 AM
:(  you will need to do something with carbs....
i have install other exhaust....its works good...but its isnt enoughf pertol...
Title: Vance & Hines A CBR900RR S4 TI Bolt-On?
Post by: werase643 on April 25, 2004, 10:51:21 AM
yeah, ya stupid redneck....i told you to shim the needles
but do you listen....NOOOOOOO :?
dang russian rednecks :roll:
:mrgreen:
Title: Vance & Hines A CBR900RR S4 TI Bolt-On?
Post by: RoundBall on April 25, 2004, 02:06:54 PM
yep  :oops:  i will do it tomorrow  :thumb:
Text only | Text with Images