News:

New Wiki available at http://wiki.gstwins.com -Check it out or contribute today!

Main Menu

Timing missalignment

Started by rezine.mt, November 16, 2026, 02:52:49 AM

Previous topic - Next topic

rezine.mt

Hello everyone, I'm currently restoring and modifying a suzuki gs500 and I've encountered a problem: the person that did the timing on this bike in the past didn't do it properly.

Both camshaft are in their correct positions, all the markings are where they should be, but the crankshaft seems to be off by one tooth. I'm not worried about the valves colliding with the pistons, I'm worried about the engine losing some performance.

The engine started up relatively fine, it did run a little bit rought before i started dismantling the bike, but the tutorial i followed for cleaning the carbs did say that bike would run rough for a bit. The intake valves open a little bit earlier than normal, You cannot view this attachment.I know that advancing the timing helps in occasions but will it make the engine run bad? Or is this just a trick to make mo powah?

In the picture the RT marking is in its place, but it's too big to upload :cry:

moe_tunes

The crankshaft is the reference for setting the cam timing so with the crankshaft in the right position you set set the cams up. If the cams are out of position check if the cam chain has any loose spots and might have jumped a tooth, if not you have to reposition them. It is not piston hitting valves with these engines that is a problem  it is the two valves hitting that is the issue.

Hope that helps
You're just jealous because the voices only talk to me.

SMF spam blocked by CleanTalk