CFM Rearsets

[TragicImage]

I just installed my new-ish rear sets that I picked up today from a fellow board member.... 


They're fairly awesome, I'll let you know after a canyon run or two, but I like them more than the stockers, at the moment.  They work better with my boot, for the most part.


My only question is, now my shifter feels a tad-bit too short.  Any cure for this?

[annguyen1981]

There is another bike out there that I guess the shifter will work with the CFM rearsets...  Lemme search for my old thread I started

[annguyen1981]

According to this thread
http://gstwins.com/gsboard/index.php?topic=28458.0

KZ1000 shifters will work.  I forgot what years though

[Mk1inCali]

CBR900RR will work as well.  One member here has them.

[dgyver]

Get a GSXR footpeg and install a linkage shifter. You will need to grind 2 little slots for the peg to index into. I did this when I had them.

[TragicImage]

Get a GSXR footpeg and install a linkage shifter. You will need to grind 2 little slots for the peg to index into. I did this when I had them.

eh?

[dgyver]

Get a GSXR footpeg and install a linkage shifter. You will need to grind 2 little slots for the peg to index into. I did this when I had them.

eh?

btw...this set up for GP shift. I had to use the linkage to reverse the shift pattern.

[pantablo]

oooh tricky.

[annguyen1981]

I was thinking that too.  My dad's VStar 1100 has the same type of shifter.  It took a couple trys of taking it off and putting it back on to get it to shift right.

[dgyver]

The splined knucle and tab of the pedal must be parallel to shift smoothly, otherwise it may bind.