dyno jet good or bad

[06gs500f]

hello everyone do you think this jet kit is good i had several peps recomend it if good why if bad why

[spc]

Bad.  Way overpriced.  Buy the jets individually from srinath or direct from sudco.

[06gs500f]

well i done got the kit will it be worth it to put it in i am taking to the shop friday to get it done

[06gs500f]

and will my bike run right if i get it put in i am going to take it to a shop to get it done i keep hearing about powerloss and surges from 5000 and above

[The Buddha]

OK I dont quite know for 01+ ... but they suck for older US spec GS'es.
I also dont quite stock jets for 01+ Imay after I tune them 04 carbs on the new bike I am building.
Cool.
Srinath.

[mach1]

As far as pirce they suck. You can order them from bikebandit or as terry said from sudco. The jets should be fine but from what I hear you have to drill the slide so the needle fit properly, but thats just what I have read.

[The Buddha]

You drill the slide so you can install their stupid plug ... you dont touch the hole the needle goes in ... whatever you do ... do not drill and do not lose the stock needles.
Cool.
Srinath.

[ben2go]

I was going to do a stage 3 dyno jet kit.I don't wanna drill my slides.How can you get by this?Srinath,I need something comparable to the stage 3.How much Srinath?Pm the info if you want.

[bosozoku]

Bad.  Way overpriced.  Buy the jets individually from srinath or direct from sudco.

Or from a dealer even -- mine has mains for $1.50 each and pilots for $3.00.  The Old Guy(tm) at the counter is more than happy to help and even offer jetting advice.

-b.

[06gs500f]

well in the installation instructions it makes it sound that if  you have to drill  it is the plug where the mixture screw is it does not say you have to for sure does anyone know for sure if the mixture screw is hidden under the plug i have an 06 gs500f and it makes it sound like all the jets will just fit where the old ones were it also does not say anything about drilling the slider