turn signals for naked gs

[drowningbird808]

im converting my bike to a naked one, and i have flushmounts now i need a link to after market signals that mount to the forks

[blue05twin]

Not sure if this will answer your question or not but give it a try.

http://pantablo500.tripod.com/id32.html

besides those signals look really good.

[scottpA_GS]

I dont think those mount to the forks

[ben2go]

I dont think those mount to the forks

They mount to the factory GS500E head light bracket.

[Suzuk-E]

^ That's what I did.

[scottpA_GS]

yea, but he doesnt have any if he had an f 

[CndnMax]

but if he converts it to a naked he will probably be using the E headlight, wouldn't that give him the mounts?

[Jay_wolf]

Yep , it would there attached to the main breackets for the bulb

[scratch]

Yep, unless he uses a different way to mount it.

You could use '80's Yamaha turnsignals (see avatar, oh wait, there's a picture of my bike in the gallery), or I'm waiting to get my hands on the new ('07+) Kawasaki turnsignals.

[Mk1inCali]

I used Buells, I like the smoked lense, and they are definitely brighter than the stock GS TS.  Pretty cheap, too, but after 4 yrs (2 of them parking the bike within 500 yds of the Pacific ocean), the screws were rusting.

[drowningbird808]

yeh mine is a 06 go it is a F, but i going with the dual head lights instead of a head light off a E

[ben2go]

yeh mine is a 06 go it is a F, but i going with the dual head lights instead of a head light off a E

drill a hole in the side of each bracket and bolt them on. 

[drowningbird808]

so your says mount it to the headlight bracets?

[ben2go]

so your says mount it to the headlight bracets?

yep,dats how da factory does it.lay both brackets together if they're flat and drill through both.then you will have the holes on both in the same place. 

[scottpA_GS]

I duno what the F model brackets look like  Can you take a pic?

Aside from that... If you are mounting duel headlights the bracket will prob not support signals 

[CndnMax]

I duno what the F model brackets look like  Can you take a pic?

holes in the fairing? 

[philward]

I duno what the F model brackets look like  Can you take a pic?

Aside from that... If you are mounting duel headlights the bracket will prob not support signals 

The stock E brackets look like this:



They go on each of the fork tubes.  There are 2 triangular cheek pieces that connect this bracket to the sides of the lights (not shown, but easy to see on most pictures of the 500e).

When I mounted dual headlights I found that the triangular cheek pieces weren't quite long enough to stop the back of the light fouling the fork brackets (and speedo cable).  So you can either make your own (pretty easy) or poke about in the wreckers for something that can be modified to suit.

And yes, the turn signals in the E bracket do fit with dualies... (they sit beneath the light)

[ben2go]

dgyver has dual head lights,aztec I think and those brackets are beefy and would take a signal without a problem.

[drowningbird808]

i want somethign like this http://cgi.stanford.edu/~sanjayd/gs500/Upgrades/DualHeadlights

[ben2go]

here's the link to the lights      http://aztec8.com/catalog/c7_p1.html

here's the matching signals     http://aztec8.com/catalog/c5_p1.html