carb parts needed

[jeremy_nash]

i need a set of the plastic housing off the top of the carbs for my 94gs.

[The Buddha]

This I am almost sure I have, how is $10 ??
I tey you fo sho tommory ...
Cool.
Srinath.

[jeremy_nash]

don't need them now.  after looking at a parts explosion, I realized I didn't need those nipples on them after all, so I just hot-glued the inside of them............but thanks anyway

[The Buddha]

OK clown ... hot glue there isn't the best idea ... I would rather use a little round O shaped inner tube bit if that vacuum spigot is broken.
Cool.
Srinath.

[jeremy_nash]

I've got a piece of inner tube in place of the oring.  I just hot-glued it over the top to keep water from getting in it and freezing.

[p51mustang]

  Hry Guys,

I'm needing Diphragms for a 1999 GS,
Mine have pin size holes,NAPA parts store said to Epoxy for Rubber, Just a thin coat over holes.
anyone tried this? I was thinging the Epoxy will make a vacuum delay on one carb-on the piston valve Austin TX, [p51]

[ben2go]

If someone here doesn't have them,Srinath should,try this guy.He had them for $20 each.Just message him on his Ebay site.I have made alot of purchases from him when I couldn't get parts here or locally.

http://stores.ebay.com/GEORGEFIXS-MOTORCYCLE-PARTS