FS '95 GS 500

[Afzzr12]

I bought this bike 2 years ago and completely rebuilt everything.  I tore the engine completely down.  It got new bearings, new rings, a thorough cleaning, and a little bit of porting.  The porting was nothing more than removing the cast lines from the exhaust side.  I replaced all the wheel bearings, swingarm bearings, headstem bearings.  The front and rear brake pads have about 40 miles on them now.  The chain and sprockets have about 5000 miles.  It could use a new set of tires, but they have about 500 miles left.  The forks have had preload spacers installed and 20W oil for a heavier rider.  It has a Wylico exhaust, K&N unifilter, and has been jetted to match.  The tank was Kreamed when I did the rebuilt.  I just cleaned the carbs, checked the lash on the valves, and balanced the carbs in prep for the sale.  This bike is ready to roll.  I hate to let it go because I have put so much work into it.  My wife supposed to ride it, but she ended up being scared of bikes and never got into it in 2 years.  I figure it is time to move on and put the money into some of my other hobbies. 

$1300 OBO

I am located in Wichita Falls, TX and am willing to drive 100 miles to deliver/meet the buyer.

If you want to ship it you will have to coordinate it.

I will post pics up tomorrow.  The weather was nasty here all day and I couldn't get good lighting.  This is the only place I am going to post this for a week.  After that it is going to go on craigslist, newspaper, and other local outlets to try to sell it faster.

Please feel free to pm me with any questions.  I am more than happy to answer anything about the bike.

I am not parting anything


Alex