Um...how do I remove the float?

[Kijona]

Can somebody explain how to remove the float assembly from the inside of the carb? It looks like it just pulls out but I don't want to break it.

[Dizzledan]

It looks like it just pulls out

Yup. Pull it at the contact point with the carbs, dont pull at the actual floats or anything.

[craigs449]

Should be a gold colored phillips head screw that holds it all in there.  Unscrew that, then gently pull the assembly out, being sure not to lose the needle valve or the metal reatainer pi.

[Kijona]

No screw. I assume the newer ones have screws? Mine's a 98.

[Big Rich]

There should be a pin going left to right at the base of the actual float. Pull it out, but be careful that the float needle doesn't fall out and run across the floor.......

[Kijona]

I got it. The whole thing comes out as one piece.

[Paulcet]

No screw. I assume the newer ones have screws? Mine's a 98.

Correct.  Advice you get on the 'net is worth exactly what you pay for it!

[The Buddha]

The 89-00 carbs floats are on there with mostly an O ring and good fortune.
Cool.
Buddha.

[craigs449]

No screw. I assume the newer ones have screws? Mine's a 98.

oops, didn't know the older ones had no screw holding the assembly in.......assumed they were all like my 01'